HP Implementing HP Network Technologies 認定 HP0-Y46 試験問題:

1. Refer to the network exhibit.

Assume the network shown in the exhibit has implemented RSTP Based on the topology, which ports are root ports? (Select two)

A) SwitchB port 1
B) SwitchC port 2
C) SwitchB port 2
D) SwitchA port 2
E) SwitchD port 2

2. A network administrator is connected to the console of an HP Comware switch when these messages display:

Based on this information, what has just occurred?

A) The main processor card on a 7500 switch has become active.
B) A 10 GbE line card was inserted into the slot of the Comware switch.
C) The second processor card on a 5820 switch has become active.
D) Another member has joined the IRF topology.

3. Refer to the network exhibit.

A network administrator needs to configure DHCP on an HP Comware switch. The network administrator configures the following information:

After setting up DHCP relay, the network administrator has the DHCP client try to acquire addressing information, but the process fails. What should the network administrator do to solve this problem?

A) Configure DHCP relay on SwitchB.
B) Execute the routing command on SwitchA.
C) Enable DHCP Snooping on SwitchA.
D) Execute the dhcp enable command on SwitchA.

4. A network administrator configures the following information on an HP Provision switch:
Provision(config)# spanning tree
Provision(config)# spanning tree instance 0 priority 2
Based on this information, what is the priority assigned to this switch for instance 0?

A) 2
B) 4.096
C) 16.384
D) 9
E) 8.192

5. Which URLs can a network administrator use to access IMC? (Select two.)

A) http://<<ip-address> | <hostname>>:8080/imc
B) http://<<ip-address> | <hostname>>:8000
C) http://<<ip-address> | <hostname>>:8443/imc
D) http://<<ip-address> | <hostname>>
E) http://<<ip-address> | <hostname>>:8043

質問と回答：