H3C Constructing H3C High-Performance Campus Networks 認定 GB0-371-ENU 試験問題:

1. In the networking model shown in the figure, after the configuration is completed, it is found that the user authentication fails, then the possible cause of the failure is

A) No default domain is specified on RADIUSClient
B) The message shared key between RADIUS Server and RADIUs Client is inconsistent
C) The username is not configured on the RADIUSServer
D) The network cable between RADIUS Server and RADIUs Client is not connected

2. Among the following PIMV2 messages, the destination address is a unicast address:

A) Prune
B) Graft
C) Hello
D) Assert
E) Join
F) Register

3. The security of the campus network should consider which of the following developments

A) Protect the physical circuit
B) Effectively identify legal and illegal users
C) Effective management of network equipment and network topology
D) Effective access control

4. Which of the following aspects should be considered for the security of the campus network?

A) Protect the physical circuit
B) Effectively identify legal and illegal users
C) Effective management of network equipment and network topology
D) Effective access control

5. After executing the display interface Ethernet 1/0/1 command on the switch SWA, the output information is as follows:
[SWA]display interface Ethernet 1/0/1
Ethernet1/0/1 current state: UP
PVID: 10
Mdi type: auto
Link delay is 0(sec)
Port link-type: trunk
VLAN passing: 1 (default vlan), 10
VLAN permitted: 1 (default vlan), 2-4094
Trunk port encapsulation: IEEE 802.1q
Port priority: 0
It can be judged from the above output

A) Port Ethernet1/0 is a Trunk port, which only allows data frames of VLAN 10 to pass through
B) Data frames with VLAN1 tags will not be discarded when they enter Ethernet1/0/1
C) Data frames without VLAN tags will be tagged with VLAN10 when they enter the port Ethernet1/0/1
D) Data frames with VLAN10 tags will not be stripped off when Ethernet1/0/1

質問と回答：